Initial Configuration of Linksys SPA3102

Initial Confiuration of Linksys SPA3102

Here is what I have done so far ( I have omitted steps that lead to a dead end).

Unpacked and connected cables:
Network cable from my existing router went to “internet” port.
Placed a splitter in the dsl phone line, ran the data side back to the router.
Connected cable from the dsl splitter to the “line” port.
Connected an analog phone to the “phone” port.
Connected the power supply.

With the analog phone:
(had to disconnect the “line” port, evidently default config is to connect the analog phone to the line which messes up the IVR capability of the analog phone)
Dialed ****
Dialed 110# --> msg received: 192.168.1.117
Dialed 7932# 1# 1# --> msg recv: configuration saved (enabled web interface)

From PC connected to the same network:
Browse to 192.168.1.117
Click on Admin Logon
Tab to Wan Setup
Change configuration to:
Connection Type: Static
Static IP: 192.168.1.2
NetMask: 255.255.255.0
Gateway: 192.168.1.1
DNS 208.67.222.222, 208.67.220.220

Downloaded a firmware upgrade from http://www.cisco.com/en/US/products/ps10027/index.html
Upgraded from 3.x to 5.1

Reattached Browser to 192.168.1.2
set admin & user password to ***
Closed browser & reattached
Login OK, it only logs in as user and then allows upgrade to admin

Added SIP access from my router on this network.